Duză de pulverizare duală Rain Bird 12DSH, model în jumătate de cerc de 180°, distanță de pulverizare 9' - 12' Semi-cerc Model 180° semicerc de 180°

Brand:Rain Bird

3.7/5

L
114.11

DESCRIEREA PRODUSULUI Rain Bird 12DSH Pulverizare dublă 180° Model în jumătate de cerc Duză cu rata de precipitații potrivită, Distanța de pulverizare reglabilă de la 9’ la 12’, Traiectorie de 23°. Această duză specială are două orificii de pulverizare pentru o udare mai apropiată îmbunătățită și o distribuție mai uniformă a apei. Designul unic patentat reduce timpul de udare, folosește cu 30% mai puțină apă și reduce risipa de apă în condiții de vânt. Zonele apropiate de cap beneficiază de o acoperire uniformă, minimizând petele maro uscate. Construcție din plastic non-coroziv și oțel inoxidabil pentru o viață lungă. Șurubul de reglare din oțel inoxidabil reglează debitul de la 1,8 la 2,6 galoane pe minut și distanța de pulverizare de la 9’ la 12’. Fanta pentru șurub capturat previne alunecarea șurubelniței în timpul ajustării. Duza pulverizează un model de semicerc de 180° la o traiectorie de 23° și se potrivește tuturor aspersoarelor și adaptoarelor pentru arbusti Rain Bird. Filtrul cu plasă fină menține reglarea precisă a razei și protejează orificiul inferior de reziduuri. De încredere de zeci de ani, duzele Rain Bird MPR dispun de tehnologia de distribuție a apei cu rata de precipitații egală. Duzele cu arcuri și raze diferite pot fi amestecate pe aceeași zonă, indiferent de reglarea pulverizării și mențin totuși ratele uniforme de distribuție a apei. Este disponibilă o gamă largă de duze MPR, astfel încât distribuția apei să poată fi adaptată pentru a satisface nevoile unice și diverse ale peisajului dumneavoastră. Duzele MPR sunt proiectate pentru a oferi o acoperire uniformă, asigurând că gazonul dumneavoastră este verde pe tot parcursul, fără pete uscate sau maro. Alte duze Dual Spray MPR disponibile (vândute separat) sunt: ​​modele 360° pline (12DSF) și 90° sfert (12DSQ). Rain Bird „Utilizarea inteligentă a apei DE LA PRODUCĂTOR Rain Bird Corporation este o companie privată fondată în 1933 în timpul boom-ului agricol din California. Suntem recunoscuți ca producătorul și furnizorul numărul 1 de produse și servicii de irigare din lume. Cu birouri de vânzări pe tot globul; oferim peste 4.000 de produse de irigare care economisesc apă în peste 130 de țări. Încă de la început, Rain Bird a produs și oferit cea mai largă gamă de produse de irigare de înaltă calitate din industrie pentru: ferme, terenuri de golf, arene sportive, dezvoltări comerciale și case. În ultimii 80 de ani, Rain Bird a primit peste 450 de brevete în întreaga lume. Inclusiv primul pentru irigare în 1935 pe aspersoarele noastre originale cu acționare cu impact (brevetul SUA nr. 1.997.901) care a revoluționat producția de alimente agricole și a inaugurat o nouă eră în irigații la nivel mondial. În 1990, acest aspersor cu impact original a fost desemnat un reper istoric de către Societatea Americană a Inginerilor Agricoli. Produsele noastre acoperă toate aspectele de irigare... temporizatoare/controlere, aspersoare rotative pop-up, aspersoare pop-up cu cap de pulverizare, duze de stropire, supape de irigare, irigare prin picurare, drenaj și multe altele. Aceste produse au fost alese și instalate la nivel mondial în cele mai mari și prestigioase proiecte de irigare rezidențială, comercială, agricolă și terenuri de golf. Rain Bird se angajează să utilizeze Intelligent Use of Water™, extinzându-se dincolo de produse la educație, formare și servicii pentru industrie și comunitate. Moștenirea noastră este să proiectăm și să fabricăm numai produse de cea mai înaltă valoare și calitate. Suntem recunoscători că am primit numeroase premii de recunoaștere de la mulți dintre partenerii noștri valoroși. Rain Bird „Utilizarea inteligentă a apei

Construit din materiale foarte durabile UV și rezistente la chimicale pentru a asigura o viață lungă. Șurubul de reglare din oțel inoxidabil reglează debitul și distanța de pulverizare. Elimina petele maro uscate din apropierea capetelor. Compatibil cu toate aspersoarele pop-up Rain Bird. Model de semicerc de 180° cu distanță de pulverizare reglabilă de la 9’ la 12’. Folosește cu 30% mai puțină apă; reduce risipa de apă în condiții de vânt. Duze de pulverizare duble pentru udare superioară.
Brand Rain Bird
Color Brown/Black
Country of Origin USA
Customer Reviews 4.7 4.7 out of 5 stars 276 ratings 4.7 out of 5 stars
Domestic Shipping Item can be shipped within U.S.
International Shipping This item can be shipped to select countries outside of the U.S. Learn More
Is Discontinued By Manufacturer No
Item Dimensions LxWxH 0.89 x 0.89 x 2.1 inches
Item model number 12DSH
Item Weight 0.022 ounces
Manufacturer Rain Bird
Material Stainless Steel
Product Dimensions 0.89 x 0.89 x 2.1 inches
Style Pop-Up

3.7

7 Review
5 Star
75
4 Star
20
3 Star
3
2 Star
0
1 Star
2

Scrie o recenzie

E-mailul dvs. nu va fi publicat. Toate câmpurile obligatorii sunt marcate cu*

Scritto da: Eugene
Better near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Eugene
Good near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Dazzza
Great Replacement at Low Cost
These nozzles fit the 1800 series and UNI-Spray series sprinkler head bodies. They will also fit onto most other brands of sprinklers that use universal female thread nozzles. While Rainbird makes a wide range of nozzles, most are only available at specialty irrigation stores. Hardware stores and home centers tend to only carry a few of the most common nozzles. Rainbird makes a very good nozzle set with good water spray uniformity. Many of them have matched precipitation rates so you can mix different radius and pattern nozzles on the same valve zone without messing up the water application uniformity. Be careful of this as Rainbird's literature calls all of their nozzles "matched precipitation rate", but that does not mean they are all compatible with each other! For example, you should not use a 4 series VAN nozzle on the same valve circuit as a 5 series MPR nozzle. Read the nozzle descriptions for each series of nozzles below for details on which nozzles are compatible. The spray radius can be reduced up to 25% on all but a few specialty bubbler nozzles using a screw on top of the nozzle. Note that the separate screen must be installed under the nozzle for the radius adjustment to work correctly. If you remove or don't install the screen you won't be able to adjust the radius. The screens are provided with the nozzles when you purchase them. All Rainbird nozzles are constructed of high-quality plastic.
Scritto da: Padmapada
Easy fix for a damaged sprinkler head, saved lots of $$$
The folks who cut my grass tend to cut the heads off the sprinklers with their machines. In the past, I've called the sprinkler company to fix them, and ended up paying hefty service calls. This time I had a look and saw that the damaged head simply unscrewed. So I went to the local big box store and tried to find a replacement. The clerk tried to talk me into buying something that had threads on the OUTSIDE because, I guess, that is what he had in stock. But I needed a head with threads on the inside, one that would just screw down on top of the pop-up pipe. I saw this on Amazon and asked other customers if it had threads on the inside, and the answer was positive. So I bought this, and it took about 2 minutes to install. The head is clearly marked so that you can see which way the spray goes (this is a half circle), and there is a screw on top to reduce the diameter if you want. It is installed in the berm, or tree lawn, or verge, or curb strip, or whatever you call that narrow strip of lawn between the sidewalk and the street. Perfect. Good for all dialects.
Scritto da: Cindy
Good product
Product fit as described
Scritto da: Amazon Customer
Performance met the product description.
Did a lot better than the water savors you can buy.
Scritto da: Brenda Brennan
Perfect fit
Perfect to replace broken sprinkler head.

Produse asemanatoare

hot
Pompă zero
3.5/5

L 590.58

Pompă zero
3.5/5

L 590.58

Descoperiți rețeaua noastră internațională

Expediem în 28 de țări, peste 200.000 de produse. Fii la curent, abonează-te la newsletter.

Array